Back to Top
Data Logger Shield for Arduino
Features:
- Cards formatted in FAT16 or FAT32 can be used with the SD card interface. 3.3 volt level shifter circuitry built in allows for extremely quick reading and writing while guarding against SD card damage.
- Even after the Arduino is disconnected, the real-time clock (RTC) continues to run the time.
- The backup coin cell battery lasts for many years.
- You may get started right away because SD and RTC example code and libraries are included.
- Soldering connections, circuits, or sensors in a prototyping area.
- Two LEDs that can be configured as indicators
In addition to serving as a dependable reference voltage, the onboard 3.3 volt regulator also steadily powers SD cards that consume a lot of energy. - It is compatible with a wide range of Arduinos and Arduino-compatibles since it uses the "R3 layout" for I2C and ICSP/SPI ports.
This updated version is compatible with:
- Compatible with the Arduino UNO or ATmega328 - 4 analog channels with a resolution of 10 bits, or 6 if the RTC is not being used
- Compatibility with Arduino Leonardo or ATmega32u4 - 12 analog channels with 10 bit resolution
- Arduino Mega or ATmega2560 compatible - 16 analog inputs (10-bit)
- Six analog inputs (12-bit) compatible with the Arduino Zero or ATSAMD21
- Compatible with the Arduino Due - 12 analog inputs (12-bit)
Write Your Own Review
Bestsellers
10/100/1000 5 Port Switch
ZAR 1,230.43
ZAR 1,069.94
Battery to Inverter Cable 2,5m Length x 25mm Positive & Negative
ZAR 1,633.00
ZAR 1,420.00
